E 2293 - Victorian Style Keyed Mortise Entry Lock Set with Brass Finish Knobs

This vintage style mortise lock set is constructed of case-hardened steel and comes in a brass plated finish. This lock set is designed for indoor use only, and it can be installed on both 1-3/8 in. and 1-3/4 in. thick doors. The lock bolt is key-activated from both the inside and outside of door, and the latch bolt is reversible for use on both left-hand and right-hand swinging doors (See the manufacturer’s How-To Video to view simple steps required for reversing latch bolt). This classic style mortise lock set features a 2-3/8 in. backset, antique skeleton (bit) keys and large 7 in. tall escutcheon plates. Knob and lock sets like these are used by many for matching or replacing vintage type hardware, and they’re simple to install. Spare keys are available through special order. Note: This item cannot be installed on pre-bored doors that have large, newer style door knob holes without first prepping them to receive this hardware. Installation will require a 5/8 in. wide x 4 in. tall x 3-1/8 in. deep pocket to be mortised into the door’s edge. *Installation tip #1: Because the fasteners of the rosettes require a solid surface to mount to, the large 2-1/8 in. (approximate size) holes must first be filled with a hardening filler, to then be able to receive the rosette fasteners. Products like Fix-It-All® and Bondo Body Filler® have worked well for some, but care must be used to avoid damaging any prefinished door surfaces during application and finishing. *Installation tip #2: Apply a small amount of Loctite ThreadLocker 271® to the set screw threads in the event they are loosening (Loctite® must be purchased separately).
  • Used to replace missing or damaged indoor mortise lock sets, or for new installs. Note: For interior doors only
  • Can be installed on 1-3/8 in. and 1-3/4 in. thick interior doors, requires mortise pocket to be 5/8 in. wide x 4 in. tall x 3-1/8 in. deep
  • Non-handed, reversible latch bolt allows for use on both left and right-handed swinging doors
  • Constructed of case hardened steel with a polished brass finish
  • Lock bolt is skeleton key-activated from either side of door
  • Mortise style lock body inserts into mortise pocket on edge of door
  • Knobs are 2-1/4 in. diameter with a 1-3/4 in. projection from base of knob (threaded knob shafts screw onto square spindle and lock on with set screws)
  • Please refer to the line art drawing for dimensions and compare with your needs before purchasing
Position of Keyway:
How-To Video English Embed:
Where To Buy